2. maemo4 — Compiling/Installing on Maemo 4

The compilation process for maemo is done using Scratchbox, because of hardware limitation that can disrupt the process, the installation is done by .deb packages.

2.1. Compiling Qt BRisa in Maemo 4 (Via Scratchbox)

The first thing you need to do is to install libqxt in your system. You can do that by direct installing the .deb file typing the following command inside the folder you downloaded the file

$ dpkg -i libqxt-dev_0.5.0maemo_all.deb

Or by compiling in Scratchbox and then installing it

$ sudo  apt-get install cdbs             (Done in device and Scratchbox)
$ sudo  apt-get install libqt4-dev       (Done in device and Scratchbox)
$ cd /brisa-cpp/trunk/dependencies/libqxt
$ dpkg-buildpackage
$ cd ..
$ dpkg -i libqxt-dev_0.5.0maemo_all.deb  (Done in device and Scratchbox)

And after that you need to compile Qt BRisa (via Scratchbox) typing

$ cd /brisa-cpp/trunk/brisa-cpp
$ dpkg-buildpackage

Now you are ready to install Qt BRisa

2.2. Installing Qt BRisa on Maemo 4

To install Qt BRisa in Maemo 4 you just need to download the libbrisa-dev_0.4.0maemo_all.deb file and type the following command inside the folder you put it

$ sudo dpkg -i libbrisa-dev_0.4.0maemo_all.deb

Remember that you need to have libqxt installed (look the Compiling Qt BRisa in Maemo 4 (Via Scratchbox) session).